by Rini Mon Mar 30, 2020 5:33 amOld Gladius Puppet Reg: https://gladiusrp.forumotion.com/t2874-rini-s-puppets
Approved Puppets:
- Code:
[b]Name:[/b]
[b]Rank:[/b]
[b]Materials:[/b]
[b]Weapons:[/b]
[b]Defenses:[/b]
[b]Stats:[/b]
[b]General Description:[/b]
[b]Requirements:[/b]
[b]Weaknesses:[/b]
[b]Price:[/b]
Approved Puppets:
- Spoiler:
- C-001 Combat Puppet:
- Name: Model C-001
Rank: C
Materials: 4x 1 Liter Petroleum Canisters, 4x 1 Liter Water Canisters, 2x 3 Liter Pressurized Air Canisters, 4x Piping 15ft each (cut down for the framework and weaponry, pipes), 20 lbs of Iron, 20 lbs of Bronze, 10 lbs of Copper, 80 senbon, Chain 15ft, 80 lbs of Cement Mix for Concrete, Transducer
Weapons:
Each weapon that uses the canisters consumes 1/4 of a liter per post when utilized.
Senbon launchers located in the knuckles of each hand, as well as the mouth of the puppet. 20 senbon are loaded into each arm, which can be launched out, and 40 senbon are loaded into the mouth, able to be launched as well. The senbon are launched at C rank force, at B rank speeds for 10 meters, C rank speed for 10 meters, D rank speed for 10 meters, and E rank speed for a final 10 meters, with the force dropping off a tier after 20 meters have been travelled, and then every 10 meters after. (C rank power at B and C speeds, D rank power at D speeds, and E rank power at E speeds)
Left arm: C rank Flamethrower, C rank Wind blast. Senbon Launcher.
From the bottom of the forearm, a slot is made for an opening, where a metal tube is made that extends out. The tube is connected to petroleum cans in the upper arm and back, which fuel the flame thrower's fuel source. A quick spark can be induced at the entrance of the tube to trigger a tiny flame. From the palm of the hand is an opening for a pipe that runs up the puppet's arm, connected to two pressurized air canisters filled with 3 liters of air each, located in the body of the puppet.
The Air palm can be fired as a thin stream for slices, as the opening of the palm has a slot that shifts open and closed to make it thinner, or it can be a bit more wide, for use with pushing people or projectiles back or further. The air has a maximum range of 30 meters.
The Flame thrower has a range of 30 meters and creates a stream of fire that widens out a meter every 5 meters to 6 meters wide. Both have speeds of C.
The Air and Flame throwers can be used in conjunction with each other to increase the power, although in doing so, it drains the reserves of both the petroleum and pressurized air canisters at the same time, and if any are empty, this cannot be utilized. When this is done, the power of the combined Flame is considered B, although all ranges and speeds stay the same.
------
Right arm: C rank Transducer taser, C rank Water Pressure/Petroleum hose, Chain Whip
The palm of this hand is made of a highly conductive metal, copper. The transducer built into the arm allows the puppet to electrify anything it grabs, assuming the material is conductive, or can be used to electrify basic strikes.
The taser itself has no range beyond touch, but when grabbing the chain, can channel the charge through it. Additionally, the water coming from the palm can be electrified as well.
The water, much like the wind, can shift into two modes. A pressure hose with cutting capabilities of C rank, or a blast that knocks things back with C rank power, with a speed of C.
A chain is built into the concrete of the arm, with a housing chamber to allow it to slip out and extend when an opening is triggered. It's completely built into a concrete base, with a release mechanism made to let the chain free.
Defenses: This model was made more for offense than it was for defense. However, the materials that make up this puppet are quite durable in and of themselves. Knocking the puppet around isn't that difficult, but destroying it completely is a little bit more difficult.
Stats: Str: C | Con: C
General Description: This model of Rini's puppets is her first attempt to make a combat viable puppet specifically designed for fighting, rather than any models she's previously made that were supplementary at best. The puppet itself is humanoid in shape, about 5'9" in size, and weighing close to 175 pounds.
The puppet is made out of a mixture of Iron, Bronze, Copper, and Concrete, in order to give it weight and durability. There are grates that can be locked and unlocked so that Rini can replace some of the puppet's internals, but for the most part it's a set frame. The main body of the puppet is covered in 2 inches of concrete, to give it a thick skin, with an iron and bronze bodice underneath.
Rini chose concrete because when it gets chipped away, the parts underneath still are durable, which would allow her to make quick repairs by just slapping on more concrete mix over any areas that needed patching.
The puppet looks like a stone golem in the vague likeness of a person, but the metal interior is noticeable at the joints of the puppet, given that Rini couldn't cover those without imobilizing the puppet.
Requirements: N/a
Weaknesses: Since so many of the puppet's weaponry relies on canisters, it largely runs out of its offensive capabilities when those are destroyed or run out of juice. While there are backup canisters in the torso and arms, removing the arms throws out so much of the puppet's combat capabilities that it is virtually useless at that point as a weapons platform.
The joints of the puppet couldn't be reinforced with concrete, so they are obvious weak points. In order for Rini to open up the puppet, there are grates on the arms and chest that she can remove to access the internals, and targeting those gives access to the canisters and internals.
Price: 15,000 ryo + 10,000 ryo = 25,000 total
